|
Post by davy on Sept 13, 2016 17:06:16 GMT
Yip relegated to back garden,was even suggested I should have taken the allotment I was offered a couple of years ago,,at two mile away I would have made them happy noise wise...can't wait till I get good at it and you get the next obvious question,,,can yo do one for me....spin bitch 😉
|
|
|
Post by davy on Sept 13, 2016 17:19:57 GMT
I see you can buy a tool that presses a design into belts via a mill tool,,can't seem to find a cheap one in UK.. still waiting on studs coming to allow buckles to be interchanged,i found a process I didn't know about for making a design on a buckle blank,,, salt water etching,, brilliant process ,, tub of salty was water,a 12v DC power supply (car battery charger) fit negative lead to back of metal,cut a vinyl stencil to the metal and mask off all other bare metal apart from stencil ..place in a tub of salty water,,fit positive lead to a piece of scrap copper and place in salt water.. switch on power,, wear personal protection..and watch solution fizz and scum up water,, leave for a set time,, short time = light etch ,longer gives deeper etch.. Check out utube for tutorials on different methods of this... well worth watching.
|
|